32′ x 32′
Yes, there is no manual setup procedure.
You need to parallel the monitoring wires with the power wires.
The sensor locks out the remote feature after 30 minutes of idle time. You must power cycle the sensor to access the remote feature again.
A lock code has been set. If you power cycle the sensor, you can unlock the sensor and then press LOCK > 0000 to clear the lock code.
Press UNLOCK > MAGIC WAND > MAGIC WAND. This turns on 3 visible LEDs used to align the sensor.
The relay output is most likely set incorrectly.
No. It must be powered with DC voltage.
Yes. You can increase the immunity filter, increase object size, and increase output activation delay.
Only if there is not a lot of moisture or fog. The lens needs to be clear.